Hi,
I have a few of the "Blue Pill" STM 32 boards and I've been programming them using a serial FTDI232 module and the Arduino IDE.
Recently I've obtained a couple of "Black Pill" boards that have the mounting holes in the corners of the board. These also have less pins on the headers (only 17 pins on each side as opposed to the 20 pins on each header on the Blue Pill).
This "Black Pill" board also won't accept 5 volts so I'm using 3.3volts to run it and it runs just fine. However I...
STM32 "Black Pill" Serial Programming pins?
I have a few of the "Blue Pill" STM 32 boards and I've been programming them using a serial FTDI232 module and the Arduino IDE.
Recently I've obtained a couple of "Black Pill" boards that have the mounting holes in the corners of the board. These also have less pins on the headers (only 17 pins on each side as opposed to the 20 pins on each header on the Blue Pill).
This "Black Pill" board also won't accept 5 volts so I'm using 3.3volts to run it and it runs just fine. However I...
STM32 "Black Pill" Serial Programming pins?