Hello All,
Ok I am old but stubborn, so am going to follow this issue through regardless, my question / problem is as follows :
What is the most simplistic way to design a circuit board that will supply current to a small pager motor at varied intervals & duration.
IE : Run pager for 1 sec on 1 sec off, 3 sec interval then repeat, then on for 5 sec off for 2 sec and then continue to repeat that entire cycle pattern.
The cycling pattern will never be altered so can you program a small mc...
New but asking for help with MC / PWM ?
Ok I am old but stubborn, so am going to follow this issue through regardless, my question / problem is as follows :
What is the most simplistic way to design a circuit board that will supply current to a small pager motor at varied intervals & duration.
IE : Run pager for 1 sec on 1 sec off, 3 sec interval then repeat, then on for 5 sec off for 2 sec and then continue to repeat that entire cycle pattern.
The cycling pattern will never be altered so can you program a small mc...
New but asking for help with MC / PWM ?
